Digital Vernier Calipers

1.Open slider 2.Heat treatment of high frequency Specifications

1.Range: 0-300mm/0-12inch 2.Material:stainless steel (4cr13) 3.Four-way measurements 4.certificate:CE 5.Display: LCD

  •SPECIFICATIONS

1.size: 41.5 cm           

2.packing details:

QTY PER CTN	N.W/G.W	CTN SIZE
20 PCS	16/18KG	46X31X27 cm

3. material: 4cr13

4.package: plastic casing or blister with paper card or according to your requirements.

•TECHNICAL SPECIFICATIONS

1.Outside Jaws:           Measure External Length

2.Inside Jaws:              Measure Internal Length

3.Measuring Range:     0-300mm/0-12in

4.Resolution:                  0.01mm/ 0.0005in

5.Accuracy:                     ± 0.02mm/ 0.001in (<100mm)

                                    ±0.03mm/0.001in(>100-200mm)                                      

6.Repeatability:               0.01mm / 0.0005in

7.Max Measuring Speed: 1.5m/sec, 60in/sec

8.Measuring System:       Linear Capacitance measuring system

9.Display:                         LCD Screen

10.Construction Material:  Stainless Steel

11.Power:                          One alkaline lithium button cell battery 1.5v,TYPE LR44.

                                      Capacity-180MAH

12.Working  Temperature: 5°c-40°c/41 to 104 degree f

13.Note:                  Accuracy affected in environments exceeding 80% relative humidity.•MAINTENANCE INSTRUCTIONS

1. Keep the calliper clean and dry (liquid can damage the slider)

2. Use a clean, dry cloth to clean all surfaces -do not use solvents or solvent based cleaners.

3. To save power, turn off the unit when not in use.

Avoid contact with electricty and /or electronic devices

•BATTERY REPLACEMENT

Flashing display indicates low battery. To replace battery, remove battery cover by sliding cover in 

the direction indicated and replace battery with positive side facing out.

•TROUBLE SHOOTING

Falure	Cause	Measure
Display flashes	Low battery	Replace battery
Display does not change when  slider is moved	System locked	Remove battery and replace after 30 seconds to reset system
Accuracy less than +/-0.001mm	Dirt in the sensor	Remove slider cover and its assembly, clean with compress air 5kgs/cm2
No display on LCD	1. improper battery position 2. Low battery	1. Remove battery cover and check  battery position  2. Replace battery.

Digital Vernier Calipers